10 Best
Wells Pumps
-
Product Highlights- Topping up the motor unscrew the brass plugs 1 and 2, fitted on top of the motor as shown in fig. 1 below, and fill the motor with pure drinking water till water overflows from the other filling hole. gently rock the motor to release air bubbles and further top up if necessary. then replace the two plugs.
- Use the eye bolts / lifting lugs for lifting / lowering the ows using appropriate equipment. keep the wire ropes remains tied for lifting of the pump set for future. to prevent the motor from getting exposed during pumping, ensure the suction strainer is fitted above the level of the motor. this is done by fitting one end of a bend to the pump suction flange and the str...
- Sd ows motors are provided with two separate 3 core pvc insulated flat cable, each of 3 meters length. repeat the procedure for both 3 core pvc flat cables from the motor to the two cables from the control panel.
- Checking rotation of ows power up the ows and observe the discharge from the pump. next interchange any two phase wires, power up the ows and observe the discharge from the pump. in case the discharge is more after interchanging any two phase wires, then the impeller is rotating in the correct direction within the volute casing. if the discharge after interchanging any ...
- Features designed for under submerged condition water applications all rotating parts are dynamically balanced for longer bearing life and vibration free smooth operation epoxy ceramic coated in the inner parts for rust free operation fitted with quality oil seal easy for installation and no platform required designed to withstand wide voltage fluctuations non overloadi...
- The brass plug 3 mounted on the bottom of the motor, is used for draining the water from within the motor. ensure all three brass plugs are tightened to prevent leakage of water from within the motor. check for leakages before lowering the ows. use prescribed pipe sizes as mentioned on the product name plate. check the level of silt at the bottom of the well. refer fig....
SHOWview product -
-
Product Highlights
- Motor phase: single phase
- Special features: stainless steel shaft of the pump set protects the pump shaft from rusting due to hard water, high grade pump castings ensures very slow rusting of pump, pump life is increases due to less rusting and wear and tear
- Material: iron
- Included components: water pump
SHOWview product -
-
Product Highlights
- Motor phase: single phase
- Special features: stainless steel shaft of the pump set protects the pump shaft from rusting due to hard water, high grade pump castings ensures very slow rusting of pump, pump life is increases due to less rusting and wear and tear
- Material: iron
- Included components: water pump
SHOWview product -
Product Highlights
- Electrical installation as far as possible, do not use multiple joints in the electrical cabling while connecting the control panel to the ows. ground the pump set using the two earth screws provided on the leg of the motor body. ensure electrical joints, if any, are properly and adequately insulated. connect the cable properly to the starter terminals to avoid loose co...
- Sd ows motors are provided with two separate 3 core pvc insulated flat cable, each of 3 meters length. repeat the procedure for both 3 core pvc flat cables from the motor to the two cables from the control panel.
- Checking rotation of ows power up the ows and observe the discharge from the pump. next interchange any two phase wires, power up the ows and observe the discharge from the pump. in case the discharge is more after interchanging any two phase wires, then the impeller is rotating in the correct direction within the volute casing. if the discharge after interchanging any ...
SHOWview product -
-
Product Highlights
- Corrosion protection: ced coating outside the pump which protect the pump from corrosion
- Extra long cable: very long 4 meter wire for connection.
- Strong body: made from highly graded casting & stainless steel material
- Standard material: high standard stainless steel nuts & ball
SHOWview product -
Product Highlights
- Stainless steel shaft with carbon bush bearing. noise free operation
- Low power consumption upto 9a. discharge upto 2.5 liters per second
- Coil burn due to dry run or improper installation / usage are not covered under warranty
- Single phase ac 220v. total head 30 m (upto 100 feet). copper winding
- 5 meter cable provided with panel board, 1 no bend and instruction manual
- 1 + 1 year extended warranty (24 months). no warranty for panel board
SHOWview product
Coupon copied
