10 Best
Submersible Water Pump For Wells
-
-
-
Product Highlights
- Topping up the motor unscrew the brass plugs 1 and 2, fitted on top of the motor as shown in fig. 1 below, and fill the motor with pure drinking water till water overflows from the other filling hole. gently rock the motor to release air bubbles and further top up if necessary. then replace the two plugs.
- Use the eye bolts / lifting lugs for lifting / lowering the ows using appropriate equipment. keep the wire ropes remains tied for lifting of the pump set for future. to prevent the motor from getting exposed during pumping, ensure the suction strainer is fitted above the level of the motor. this is done by fitting one end of a bend to the pump suction flange and the str...
- Sd ows motors are provided with two separate 3 core pvc insulated flat cable, each of 3 meters length. repeat the procedure for both 3 core pvc flat cables from the motor to the two cables from the control panel.
- Checking rotation of ows power up the ows and observe the discharge from the pump. next interchange any two phase wires, power up the ows and observe the discharge from the pump. in case the discharge is more after interchanging any two phase wires, then the impeller is rotating in the correct direction within the volute casing. if the discharge after interchanging any ...
- Features designed for under submerged condition water applications all rotating parts are dynamically balanced for longer bearing life and vibration free smooth operation epoxy ceramic coated in the inner parts for rust free operation fitted with quality oil seal easy for installation and no platform required designed to withstand wide voltage fluctuations non overloadi...
- The brass plug 3 mounted on the bottom of the motor, is used for draining the water from within the motor. ensure all three brass plugs are tightened to prevent leakage of water from within the motor. check for leakages before lowering the ows. use prescribed pipe sizes as mentioned on the product name plate. check the level of silt at the bottom of the well. refer fig....
SHOWview product -
Product Highlights
- Suitable for lifting clean water from underground water tanks & open wells : water lift capacity up to 24 meters ( 80 feet ) : water discharge size 1 inch (25mm)
- Rust preventive ss body ; stainless steel hardware. sturdy built : 5 star rated saves energy up to 70 % comparitively.
- Powerful 1 hp 100% copper winding motor ; single phase 220v : water filled type motor ( fill with clean water before installation )
- Comes with, 3 meter wire, 1 unit capacitor box for operating the pump & cable joining kit.
SHOWview product -
-
Product Highlights
- High quality gun metal ltb-4 grade bushes
- Water cooled pump fitted with high quality ss impeller
- Made of ss 410 shaft & stainless steel body for rust free operation
- Maximum flow rate : 2.3 lps
- Made of 100% insulated copper winding | single phase
- High head range of upto 60 feets
SHOWview product -
-
-
Product Highlights
- Applications: 1. domestic use, over head tanks 2. minor irrigation 3. hotels and appartments 4. gardening 5. artificial fountains sailent features 1. water lubricated thrust bearings to withstand high axial load. 2. high grade oil seal prevents the entry of sand and dust particles into the motor.
SHOWview product
Coupon copied
