7 Best
Sand Pump For Swimming Pools
-
Product Highlights- Motor: single phase version built-in-thermal protection, asynchronous, two poles, continuous operation, ip 55 protection
- Maximum flow rate : 33m3/h @ 6.8 h(m).
- Frequency: 50hz
- Materials: pump body, pump foot and diffuser in glass, loaded polypropylene, motor housing in aluminum l-2521, shaft available in ss aisi 420, impeller and seal mounting in ppo.
- Connection size : 63mm
- Horsepower: 2hp
SHOWview product -
Product Highlights
- 2. backwash :- position when operation system to purge filter of accumulated debris. this normally is necessary when filter pressure gauge read 10 psi higher than starting pressure on s clear filter.
- 5. re-circulate :- this position permits pump to continue recirculation water (chemicals, heat, etc.) without flow through filter. this is advantageous when filter or its components are being repaired or replaced. 6.waste :- this position permits draining or lowering of pool position, quickly move handle to another position to avoid air getting into pipe. 7.winterizing ...
- 1. filter :- swimming pool sand filter normal position during operation of system
- 3. rinse :- this position only used with sand filters and is designed to flush stray sand from system before returning to filter operation after back washing. 4. closed :- valve may be set in closed position when servicing filter tanks located below water level.
- Suitable with 0.5 hp pump. note :- sand media is not included
SHOWview product -
Product Highlights
- 2. backwash :- position when operation system to purge filter of accumulated debris. this normally is necessary when filter pressure gauge read 10 psi higher than starting pressure on s clear filter.
- 5. re-circulate :- this position permits pump to continue recirculation water (chemicals, heat, etc.) without flow through filter. this is advantageous when filter or its components are being repaired or replaced. 6.waste :- this position permits draining or lowering of pool position, quickly move handle to another position to avoid air getting into pipe. 7.winterizing ...
- 1. filter :- swimming pool sand filternormal position during operation of system
- 3. rinse :- this position only used with sand filters and is designed to flush stray sand from system before returning to filter operation after back washing. 4. closed :- valve may be set in closed position when servicing filter tanks located below water level.
- Suitable with 1.5 hp pump note :- sand media is not included
SHOWview product -
Product Highlights
- Motor: single phase version built-in-thermal protection, asynchronous, two poles, continuous operation, ip 55 protection.
- Phase : single phase
- Horsepower: 0.75hp
- Materials: pump body, pump foot and diffuser in glass loaded polypropylene. motor housing in aluminium l-2521, shaft available in stainless steel aisi 420 impeller and seal mounting in ppo.
- Flow rate : 15.9m3/h
- Frequency: 50hz
SHOWview product -
-
Product Highlights
- Excellent performance
- 1x bobbin wound filter 450 mm dia with sand
- Watertech systems frp bobbin wound filter with sand & multiport valve top mount (450mm diameter top-mount sand filter with valve 1 1/2")flow capacity up to 24000 ltrs per hour with 2.5 hp swimming pool pump
- High operational fluency
SHOWview product -
Product Highlights
- Excellent performance
- 1x bobbin wound filter with sand
- Watertech systems frp bobbin wound filter with sand & multiport valve top mount ( 525mm diameter top-mount sand filter with valve 1 1/2")flow capacity up to 12000 ltrs per hour with 1.5 hp swimming pool pump,sand filter & media,totally non-corrosive filter made of fiberglass
- High operational fluency
SHOWview product
Coupon copied
