10 Best
Radar Detector Under 200s
-
Product Highlights- Mounting aperture: m3 screws detection range: 1mm to 60 cm adjustable, the closer the performance more stable, white reflects the farthest distance. size: in the control panel of 42mm * 38mm * 12mm (length * width * height) small forward 25mm * 12mm * 12mm (length * width * height)
- Working voltage: dc 3.3v-5v working current: try to choose more than 1a power supply working temperature: - 10oc - +50oc
- Output interface: 6 wire interface (1234 to 4 signal output ends, + positive power, - for the negative power is ground) the output signal: ttl level (can be directly connected to i/0 microcontroller, infrared light reflected back to the sensor induction, the red indicator light, output low level; no infrared light, the indicator light does not shine, the output high.)
SHOWview product -
Product Highlights
- Cct- 6500k cool day light, lumen- 900lm, pack of 1 led bulb
- A smart led light for your home (bathroom, balcony, staircase, store room)
- 360 degree motion detection angle
- Warranty-1 year on product
- Wattage: 10 watts motion sensor smart led bulb, base-b22, input voltage : ac220~240v, 50hz
- Motion sensor b22 led bulb with automatic on/off which makes it perfect light for home
SHOWview product -
Product Highlights
- Adjustment part introduction: 1.c-tm : adjust repeat trigger time,default trigger time is 2s;increasing capacitor's capacity will make repeat trigger time longer;and actual counting trigger time can operate as below : stick capacitor on c-tm,test 9196 3-pin frequency f,repeat trigger time t=(1/f)*32768
- Pin definition: 1.3v3:3v3 power output 2.gnd:ground 3.out:control output;when detect moving objects,it will output high level 4vin:input voltage,4-28v 5.cds:enable control chip,lower than 0.7v,out will output low level all the time
- Microwave radar sensor rcwl-0516 switch module human induction board product introduction: 1.operating voltage:4-28v 2.operating current:2.8ma (typical);3ma (max) 3.detection distance:5-9m 4.transmitting power:20mw (typical);30mw (max) 5.output voltage:3.2-3.4v 6.output voltage driving capacity:100ma 7.trigger way:repeat trigger 8.output control low level:0v 9.output co...
- 3.r-cds internal vcc parallel connect with internal 1m ohm resistor to cds pin (that is 196 9-pin) by r-cds ,cds connects with photoresistor,you can close detection function at night
- Notice: 1.the right ahead of induction side should't place any metal to block 2.the front/back side should reserve more than 1cm space 3.module and installation carrier microwave radar sensor rcwl-0516 switch module human induction board:
SHOWview product -
Product Highlights
- The module has high sensitivity, long sensing distance, high reliability and large sensing angle.
- This mini doppler radar sensor module is equipped with supporting dc 4-28v wide voltage it will automatically continuously output the high level ttl signal when there is motion. 360 degree no blind angle detection and maximum 7m sensoring distance. it is perfect for diy microwave motion sensor light switch, human sensor toys, smart security devices, etc.
- The rcwl 5016 is a microwave sensing module that uses doppler radar technology to specifically detect object movement. this radar detecter is widely used in a variety of human body induction lighting
- Operating voltage: 4-28v; operating current: 2.8ma (typical); 3ma (max); detection distance: 5-7m;
- Transmitting power: 20mw (typical); 30mw (max); output voltage: 3.2-3.4v; output voltage driving capacity: 100ma;
SHOWview product -
-
-
Product Highlights
- This human body sensor has wide operating voltage range: 4.0-28.0v
- Block time, distance adjustable
- The microwave radar human body sensor has transmission signal processing control chip rcwl-9196.
- The rcw microwave sensor comes with penetrating detection capability when compared to the traditional infrared feeling pir
- The microwave sensor has output 3.3v power supply.
SHOWview product -
Product Highlights
- Non-contact, noticeably accurate response when testing for live currents.
- Helps to distinguish the earth wire and live wire of 90-1000v ac power supplier and alerts you of the high intense radiation from powered home appliances.
- Electricians, maintenance, service, safety personnel, and homeowners can quickly test for energized circuits in the workplace or at home.
- Auto power-off feature conserves and extends battery life cat iv 1000 volt rating provides expanded operation and protection.
- Item size: approx. 152 x 23 x 15mm, powered by: 2 x aaa batteries(battery is not included)
SHOWview product
Coupon copied
