3 Best
Electric Trolling Motor For Jon Boats
-
Product Highlights- More control - turns easily when steering and provides better control in wind and most weather conditions, decreasing the need for oars, it does help to keep your boat on course in the wind, and prevent the boat from spining as much when the motor is off
- Easy installation - complimentary socket wrench for easy installation, it takes only a few minutes to attach the rudder to the shaft of your small watercraft motor and can be mounted in an upright position on the front or back of the shaft. you may even mount it with the short end down (upside down) for shorter motors. a universal design for your needs
- Sturdy & durable - the rudder is made of 100% stainless steel and is equipped with stainless steel screws and jam nut to improve stability, rust and corrosion resistance. it is sturdy and durable to extend the service life and allowing you to focus more on fishing
- Universal mount - compatible with most electric trolling motors (24 to 55 thrust). ideal for use as a canoe rudder, or a inflatable pontoon rudder, kayak rudder, or pelican bass raider 10e rudder. please note, it will not work on a self deploy bow mount trolling motor
- Bow mount - fits the edge, minn kota, maxxum, and fortrex. the bow mount motor must be a hand cable pull, not self deploy. your bow mount setup needs to have 1ft shaft protruding from the end of the platform allowing enough room to attach the rudder
SHOWview product -
-
Product Highlights
- Bo motor low density | lightweight | low inertia | capability to absorb shock and vibration as a result of elastic compliance | ability to operate with minimum or no lubrication | inherent lubricity | relatively low coefficient of friction wheel car hub is reinforced nylon | sturdy | tire with sponge liner for more strength | with upgraded tire tread for greater friction
- The bo motor is ideal for diy enthusiasts. this motor set is inexpensive, small, easy to install and ideally suited for use in a mobile robot car. the 65 mm wheel is only compatible with bo motor.
- The 150 rpm dual shaft bo motor is a straight motor which gives good torque and rpm at lower operating voltages. it is geared dc motor. it is an alternative to metal gear dc motors. the 65mm wheel is made up of high-quality rubber.
- Shaft length : 7 mm motor design : l-shaped shaft diameter : 5.5 mm size : 55 x 48 x 23 mm diameter of wheel : 65 mm center shaft hole diameter (mm) : 5.4 (round edge) and 3.5 (flat edge)
- Bo motor operating voltage : 3 to 12v current (without loading) : 40-180ma rpm : 150 output torque : 0.8 kg cm wheel loading capacity (kg) : 2.5 d hole for bo motor (mm) : 6
SHOWview product
Coupon copied
