10 Best
Car Mono Amplifiers
-
-
-
-
Product Highlights
- Class a/b topology - class ‘a’ amplifiers have enormous amount of current flowing through its output transistors with no audio signal. class ‘b’ amplifiers have no current flowing through its outputs with no audio signal
- Low & high level inputs - a low level (rca) input is measured in voltages. a high level (+/- wire) input is measured in wattages. both essentially carry signal from your receiver to your amplifier to your speakers
- Switchable bass boost - bass boost allows you to adjust the low bass within the boost range to just the way you like it
- Specs - dimensions: 9.13” x 10.44” x 2.25”, weight: 4.43 lbs., speaker impedance: 2 to 8 ohm, thd @ rms output: 0.01%, s/n ratio: 102 db, frequency response: 9 hz to 50 khz, fuse quantity: 1 30 amp ato blade
- Power - 1100 max x 1 @ 2 ohms, 550 max x 1 @ 4 ohms
- Mosfet power supply - a mosfet is an electrical switch that allows the flow of electrical current. it controls the output voltage & current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry
SHOWview product -
Product Highlights
- Frequency response: 15~22khz+/-1db
- New 2020 model with 70 rms power, more than it's predecessor
- Channel- number of channels: 2/1(bridgeable)
- Power max wattage (4 ohms): 125wx2/500wx1(bridge) rated power(2 ohms =1% thd+n): 95wx2 rated power(4 ohms =1% thd+n): 70wx2 rated power(bridged 4 ohms): 190wx1
SHOWview product -
Product Highlights
- High power 4 channel class a/b car amplifier, high level input with dc offset turn on capability, 4x85 watts rms at 4 ohms and 4x120 watts rms at 2 ohms, 2x240 watts at 4ohms (bridged), pass through rca terminals, variable low pass filter, variable high pass filter, bass boost, external bass controller
SHOWview product -
Product Highlights
- Technical concept: class d, maximum total power -1000 watts, rms power ohms-1x1000 watts (1 ohm), 1x600 watts (2 ohm), 1x400 watts (4 ohm)
- Multi-way protection circuit, variable low pass crossover controls
- Mono block high power amplifiers, frequency response 10hz-30khz
- Easy installation: we make it very easy for you to install with user-manual
- Reconnended fuse type: 30ax2, thd <0.15%, dimensions: 232mm x 190mm x 57mm
SHOWview product -
Product Highlights
- 65 w x 2 (4 ohms), 85 w x 2 (2 ohms), 175 w x 1 (btl)
- Low pass filter for bass
- 500 w high power output
- Automatic thermal control
- Single sided connections ; frequency response: 5–50 khz ; total harmonic distortion at 1 khz (%): 0.05 ; low pass filter: 80 hz ; channel configuration: 2ch;1ch
SHOWview product -
Coupon copied
