9 Best
Canoe Trolling Motors
-
-
Product Highlights
- ☻design: depending on the canoe design after about 25-30 lb counterbalancing, 3" wide crossbar minimizes motor vibration.
- ☻includes: 1 * kayak motor mount bracket and all the parts needed for the installation.
- ☻material: aluminum crossbar + plastic wood, strong, stable and detachable.
- ☻easy installation: rugged heavy duty motor bracket, 28" long provides for a full range of propeller motion. hex bolts tighten the clamp bar from above and that requires no tools to mount.
- ☻suitable: works on most canoes but not all canoes.
SHOWview product -
Product Highlights
- Solid: made of polypropylene reinforced with fiberglass.
- Included hardware: five bolts, five nuts, and ten washers.
- Compatibility: the pelican transom is designed to be installed on the following kayaks: catch pwr 100 (mf10), catch mode 110 (mi11), and getaway 110 (mh10).
SHOWview product -
-
-
-
Product Highlights
- More control - turns easily when steering and provides better control in wind and most weather conditions, decreasing the need for oars, it does help to keep your boat on course in the wind, and prevent the boat from spining as much when the motor is off
- Easy installation - complimentary socket wrench for easy installation, it takes only a few minutes to attach the rudder to the shaft of your small watercraft motor and can be mounted in an upright position on the front or back of the shaft. you may even mount it with the short end down (upside down) for shorter motors. a universal design for your needs
- Sturdy & durable - the rudder is made of 100% stainless steel and is equipped with stainless steel screws and jam nut to improve stability, rust and corrosion resistance. it is sturdy and durable to extend the service life and allowing you to focus more on fishing
- Universal mount - compatible with most electric trolling motors (24 to 55 thrust). ideal for use as a canoe rudder, or a inflatable pontoon rudder, kayak rudder, or pelican bass raider 10e rudder. please note, it will not work on a self deploy bow mount trolling motor
- Bow mount - fits the edge, minn kota, maxxum, and fortrex. the bow mount motor must be a hand cable pull, not self deploy. your bow mount setup needs to have 1ft shaft protruding from the end of the platform allowing enough room to attach the rudder
SHOWview product -
Product Highlights
- 90 degree rotation can be adjusted as your need. flexible and easy to use.
- High quality spring,sturdy and durable.
- Suitable for 28, 36, 46 and 50 pounds of electric thrusters.
- Rotatable support bracket. a great hanging bracket for inflatable boat.
- Package includes: 1 piece electric trolling motor mount
SHOWview product
Coupon copied
